SKATER WIDEBODY X-2
NEW PLEASURE OPEN HATCH MODELS ARE HERE
Carbon/Kevlar & Fiber glass layup (NOT AN INLAY)
Length – 32″ / Width – 10+”
Motor – 2- 3674 2075kv brushless Pro Marine RC
ESC – 2-120a Seaking V3 programable and 6s capable
New Stinger drives. More rigid, better and more precise adjustments in up/down and length wise.
Hi Torque servo
The Skater comes with RX/TX and a Beryllium Props to get you started
No Plastic Prop and No Additional Upgrades Needed!
We put everything in one box to make your hobby easier and much more fun.
THE “SKATER X-2” IS ONLY $759*
(*plus shipping – $55 in the lower 48 states – check with us for additional/other shipping options)
Click on the Dealer Locator button. If a Dealer isn't close to you call us to order.
PREPPING BOAT X-2
When prepping your boat for the first time please follow these tips:
1. Remove flex shaft and grease
2. Tighten prop on shaft before re-installing flex shaft
3. when installing greased flex shaft leave a small gap between drive dog and strut. This will allow shaft to contract when accelerating.
4. Make sure strut is parralell with keel of sponsons.
DO NOT INSTALL BATTERY TRAYS ATTACHED TO TUNNEL AND HULL SIDES.
Taking good care and maintaining you PMRC boat will give you years of trouble free fun.
After running, please remove shaft and dry.
Always remove water out of hull. Never store with hatch on if damp. In fact, better to store with hatch off. Completely dry inside. If put away wet, damage to receiver and other electronics could and will occur.
If you run in salt water. Immediately wash with soap and water and dry. Also keep salt water away from electronics and rx. Us WD40, Corrosion X, CRC or the like to remove water and protect electronics.
BEFORE TRYING ANY PROPS, PLEASE NOTE THAT TOO LARGE OF PROP WILL CAUSE DAMAGE & VOID WARRANTY.
PLEASE CALL US AND ASK SIZES AND LOOK HERE FOR PROPS APPROVED AND TESTED BY PMRC.
ALWAYS BALANCE AND SHARPEN PROPS BEFORE INSTALLING. ALSO MAKE SURE THYE ARE MATCHED. PLEASE CALL OR ASK LOCALLY ABOUT A PROFESSIONAL PROP PERSON.